Reply within 24 hours

Why 506 Aluminum Clips Outlast 711 in High-Volume Grocery Lines

Clip Size Basics in Produce Pack Houses

Two clip sizes cover almost every bag closing job in a produce pack house: 506 and 711. They are not interchangeable, and using the smaller one where the larger belongs is the most common cause of bags opening in transit.

The Short Version

506 clips 711 clips
Profile Smaller, standard Larger, standard
Holds Net bags up to about 5 kg Thick net bags, heavy loads
Typical material Extruded PE mesh, poly bags Woven mesh, thick film, casings
Closers 506 manual and pneumatic heads 711 manual and electric clippers

If your bag is extruded mesh and the finished weight is under about 5 kg, 506 is almost always correct. If the mesh is woven, the film is thick, or the bag carries more than 5 kg, use 711.

Why the Wrong Size Fails Quietly

A 506 clip on a thick woven bag closes — the machine does not jam and the bag looks fine. What has actually happened is the clip width is too narrow. Over a full shift of thousands of bags the seal starts to slip at the edges. By the time it reaches the store shelf the bag is already leaking or the contents have shifted. This is the kind of failure that shows up at checkout instead of on your line.

The opposite mistake is common too. Using a 711 clip on a light extruded mesh bag is unnecessary. The clip is wider than needed and can stress the mesh weave enough to cause a split under normal stacking pressure. The machine keeps running, but the bag is compromised.

When to Swap to the Electric Clipper

In high-volume grocery lines the manual head will slow you down fast. Switch to the 711 electric clipper when your average output hits roughly 20–30 bags per minute. The electric version gives consistent pressure every time and frees up one operator per station. It also handles the heavier woven loads without the hand fatigue that builds up after 4–5 hours of steady manual clipping.

What to Ask Your Supplier Before You Order

  • Confirm the clip length and jaw width against your exact bag opening size — small variations change everything.
  • Ask for the holding capacity range for your bag material and finished weight. This is the part most buyers skip and then wonder why bags open at 3,000 miles away.
  • Get sample clips of both sizes for a quick test on your line. One afternoon of side-by-side runs tells you which one actually wins in your setup.
  • Check compatibility with your clipping machine head — 506 and 711 are not the same, so swapping them later is a waste of time.

Tell us what you need to pack

Send your bag size, product weight and required output per hour. We will come back with a machine recommendation and an FOB price within one working day.

Email us Products