Cling film wrapping machines are simple until the room turns cold. Most of the
problems pack houses blame on the film are really the machine and the room
working against each other. Here is what actually happens, and what to check.
The film goes stiff
Cling film stiffens as the temperature drops, and a film that wraps cleanly at
room temperature tears or wrinkles in a cold store. The fix is usually the film
grade, not the machine — a film rated for cold application keeps its stretch
where a general film goes brittle.
The machine loses tension
A wrapping machine holds the film under tension to get a tight wrap. When the
operator’s hands are cold, or the roll is heavy, the tendency is to loosen the
tension to make it easier. The result is a loose wrap that lets air in and
shortens shelf life.
Condensation gets into everything
Cold rooms are damp. Water from condensation works into the film carriage and
the sealing surface, and a wet seal is a weak seal. Wipe the sealing area down
between runs and keep the film off a cold floor where it can sweat.
What to check before you blame the film
Run the machine with a room-temperature roll and compare. If it wraps clean,
the problem is the film grade or the cold, not the machine. If it still fails,
check the tension setting and the sealing temperature.
The practical rule
Match the film to the coldest room you pack in, not the warmest. It costs a
little more per roll and saves a lot of rewraps. Tell us the temperature you
pack at and the product, and we will recommend a film and a machine setting
that hold up in the cold.