Aluminum clips are a consumable most pack houses order in bulk and forget
about. Then the season peak arrives and the clipper starts jamming, and the
clips get the blame. Most of the time the clips are fine — they were just
stored wrong.
Moisture is the real enemy
Aluminum clips are soft, and they travel and sit in cartons. If those cartons
live on a damp floor or next to a cold-store door, the clips take on moisture,
the surfaces dull, and they no longer slide through the die channel cleanly.
A dull or sticky clip jams a clipper faster than a worn die.
Keep them dry and off the floor
Store clip cartons on a pallet or shelf, not on concrete. Keep them sealed until
the line needs them, and do not open more cartons than a shift will use. An open
carton left overnight in a humid room is the most common way a good batch goes
bad.
Do not mix profiles
506 and 711 clips look close enough to mix by eye, and a single wrong clip in
the channel stops the line. Keep the profiles in separate, clearly marked bins,
and check the bin against the die when a new operator takes over the station.
Rotate the stock
Clips do not really expire, but a carton that has sat through a damp season is
not the same as a fresh one. Use the oldest first and keep the cartons off the
wall so air moves around them.
The cheap insurance
Clips are the lowest-cost part of the line and the one that stops it most often
when they are mistreated. A dry shelf, a sealed carton, and a label on the bin
costs nothing and keeps the clipper feeding clean through the peak.
If your clipper has started jamming and a clean, fresh carton does not fix it,
the problem is in the die or the alignment, not the clips. Send us a short video
and we will tell you which.