Reply within 24 hours

Tape sealing machines: the three settings that stop a bad seal

A tape sealing machine fails a carton one of three ways: the tape sits off the
seam, the tape is cut late, or the tape goes down loose. All three come back to
three settings that take minutes to check and are almost never the machine’s
fault.

Tape alignment

If the tape lands to one side of the seam, the carton is sealed on the corner
instead of the joint. Check the tape roll is seated square and the guide is set
to the carton width. A guide that drifts even a millimetre moves the tape off
the seam over a run.

Cut length

Too short and the tape peels back at the ends; too long and the tails catch on
the conveyor and pull the seal open. The cut length should leave a tail just
long enough to fold down the sides, nothing more.

Tension

The most common silent failure is loose tape. It looks sealed and is not. The
tape needs enough tension to press flat against the carton without stretching
thin or tearing the board. Adjust in small steps and test on a full carton, not
a scrap of board.

The quick check that catches all three

Run three cartons and try to peel the tape off by hand. A good seal tears the
board before it lets go of the tape. If the tape peels clean, the tension or
the board surface is the problem — check the board has no dust or wax before
you touch the machine.

When to call us

If the tape lands straight, cuts clean and still will not hold, the issue is
usually the board or a worn sealing roller. Send a photo of the carton and a
short clip of one pass and we will tell you which setting or part to change.

Tell us what you need to pack

Send your bag size, product weight and required output per hour. We will come back with a machine recommendation and an FOB price within one working day.

Email us Products